Guild of Oregon Woodworkers

7634 SW 34th Avenue Portland, OR 97219

Shop is fully functional for all machines. Shop Maintenance update

  • 26 Feb 2019 8:58 AM
    Message # 7188329
    Ken R Hall (Administrator)

    The 2 Saw Stop table saws have been checked and lubricated. The older saw had a loose screw on its wiring harness that was tightened. The holder for the riving knife on the older saw was replaced so that the knife is now easier to replace correctly. These problems may have caused some of the cartridge firings that were unexplained.

    The electrical outlet for the chop saw was malfunctioning and it was cleaned and the problems were corrected. The chop saw should now function and its vacuum should now function as expected.

    The dust collector was cleaned on 2/25/19 and the back pressure meter reported a 2.0 reading after cleaning. Please help us to keep the reading as low as possible by blowing down the filters after sessions using the large sanders. Remember to manually check the level of the chips in the barrel after every 30 minutes of use of the planer or jointer.


Contact Us

© Guild of Oregon Woodworkers

Powered by Wild Apricot Membership Software